CASE of 12x AUTOGRAPH v2 EVOLVE - Advanced Ceramic Spray Coating

AUTOGRAPH v2 EVOLVE — Advanced Ceramic Spray Coating

AUTOGRAPH v2 EVOLVE is D-TAIL LAB’s advanced ceramic spray coating that bonds at a molecular level on clear-coated paint, wheels, glass, trim, rubber mouldings, and plastics—delivering extended durability and stronger protection than traditional waxes and sealants, while being easier to apply than conventional coatings.

What AUTOGRAPH v2 Does

Fills surface pores and lays down a durable SiO₂-rich layer to boost water beading, UV resistance, and slickness—enhancing clarity and depth across exterior surfaces.

Why You Need AUTOGRAPH v2

• Advanced protection — molecular-level bonding for long-lasting results.
• High gloss & slick feel — crisp reflections with smooth wipe-off.
• Hydrophobic performance — tight beading; less water spotting.
• Up to 12 months+ durability under proper prep and maintenance.
• Easier application than traditional ceramic coatings.

Where to Use It

• Clear-coated paint (coated or uncoated)
• Gloss plastics & exterior trims
• Wheels (cool to the touch)
• Exterior glass (light application; avoid the main wiper sweep if streaking)

Directions

Surface Preparation is Key

1. Deep Clean: Thoroughly wash the vehicle to remove dirt and any old protection.
2. Decontaminate: Perform a chemical decon (e.g., PURGE iron remover) and a physical decon with a clay towel. For lubrication during claying, foam the vehicle with a pH-neutral shampoo (e.g., ORIGIN), then clay.
3. Paint Correction: If needed, correct/enhance paint using an oil-free compound and polish to maximize gloss.
4. Prepare for Bonding: Wipe all residue with a pre-coat surface prep (e.g., REVEAL) about 1 hour before application to ensure optimal bonding.

Application Instructions

1. Shake well.
2. Remove the white cap, insert the sprayer tube, and screw the sprayer onto the bottle.
3. Spray onto a foam or microfiber applicator. Work one panel at a time, ideally ≤ 40 cm × 40 cm (≈16 in × 16 in).
4. Allow a brief flash/haze (~10–20 seconds, depending on temperature and humidity).
5. Buff off with a clean, long-pile edgeless microfiber in a cross pattern until smudge-free.
6. When finished, remove the sprayer, rinse it clean, and reinstall the twist cap on the bottle.

Curing & Layering

• Second layer (optional): wait ~30 minutes before applying another coat.
• Cure time: avoid the elements/water for ~4 hours after application.

Compatibility & Care

• Safe on coated, sealed, or bare finishes; always test on sensitive trims first.
• Do not apply on hot panels or in direct sun; do not let product dry before buffing.
• Maintain with a pH-neutral wash to maximize durability.

Pairs Well With

• Edgeless 420 GSM Microfiber Towels — lint-free wipe-on and final buff.
• Multi-Purpose Microfiber Block Applicator — even application on paint and trims.
  

Good to Know

For show-car results, follow the prep sequence above (deep clean → chemical + physical decon → oil-free polish → pre-coat wipe) before applying AUTOGRAPH v2 EVOLVE.